Odorless Graphic Fixer

DESCRIPTION
Odorless Fixer is a rapid fixer without the objectionable odor of most fixers. It is suitable for use in small, closed areas with little ventilation and for use by persons with respiratory sensitivities. This non-corrosive formula can be used in both machine and manual processing of film and paper.

REPLENISHER RATES AND SPECIFICATIONS
The replenishment rate is based on the type of film or paper selected. The recommended starting rate is 0.30 to 0.50 ml of fixer replenisher per square inch of film and 0.15 ml per square inch of paper.
Working solution pH at 25°C (77°F) = 5.00
Sp. gr. at 25°C = 1.102

SUGGESTED OPERATING PARAMETERS
Dilution:
For films 1+4
For paper 1+9

Fixing times:
Films: Typical clearing time is less than 20 seconds. Fix for twice
the clearing time.
Papers: Typical clearing time is less than 15 seconds.

Fixing times can vary from 30 seconds to 1.5 minutes.
Use Odorless Indicating Short Stop to extend fixer capacity.

Temperature: For tray processing, use at 65°F to 85°F. In processors, the fixer can be used up to 105°F.

Hardener: Many papers and some films do not require hardener. The emulsions are hard enough to withstand handling and processing. If hardener is needed, use enough hardener to achieve the desired results. A suggested usage is between 2 oz. to 4 oz. per working strength gallon.

• Models: CHM-CLOGFG, CHM-CLOGF25G & CHM-CLOGF5