PD 10 Subtractive Plate Developer

PD10 Subtractive Plate Developer will process Agfa, Anacoil, Kodak (Elite & Artisan), Konica, Superior and IBF plates.

THIS DEVELOPER IS ESPECIALLY EFFECTIVE WITH KODAK SWORD EXCELL Thermal Printing Plates.

PD10 Subtractive Plate Developer can be used with any combination of the above listed plates and this chemistry. Also it can be used either in manual development or in a processor. It is suggested to use F 10 FINISHER to protect developed plates for storage or transport to the printing press.

INSTRUCTIONS:
To change developer in a processor, first drain the processor totally, of the previous developer. Flush the machine with PD10 Subtractive Plate Developer. Next, rinse the processor with water for approximately 15 minutes. Drain and dry the developer section, squeeze dry any moleton covered rollers. Fill the processor with PD10 Subtractive Plate Developer and use it as a replenisher. The ideal processing temperature should be between 68º F (20oC) and 72º F (22oC).

NOTE:
Do not dilute the developer with water or add water during processing; this will severely affect the strength processing life of the developer.

• Models: CHM-CLPD10G & CHM-CLPD105