DF 10 2in1 Plate Developer

DF10 2-in-1 Plate Developer will process and finish Agfa, Kodak (Elite & Artisan), Konica, Precision, Superior and IBF plates.

DF10 2-in-1 Plate Developer can be used with any combination of the above listed plates and this chemistry. Also it can be used either in manual development or in a processor.

INSTRUCTIONS:
To change developer in a processor, first drain the processor totally of the previous developer. Flush the machine with DF10 2-in-1 Plate Developer. Next, rinse the processor with water for approximately 15 minutes. Drain and dry the developer section, squeeze dry any moleton covered rollers. Fill the processor with DF10 2-in-1 Plate Developer and use it as a replenisher. The ideal processing temperature should be between 68º F (20oC) and 72º F (22oC).

NOTE:
Do not dilute the developer with water or add water during processing; this will severely affect the strength processing life of the developer.

• Models: CHM-CLDF10Q, CHM-CLDF10G & CHM-CLDF105